Oce OP30C Operation Manual

Also see for OP30C: Operation guide Operation guide Operation guide

Contents

133. Troubleshooting3-3 Basic troubleshooting chartIf you experience trouble while you are using this machine as a printer, refer to the table below to perform minor adjustments. If trouble persists,contact your service representative or an authorized service center.* For information in regard to general mechanical trouble with the machine, refer to the Operation Guide for your copier.ProblemNothing is printed outText is not printed correctlyPrint out is not correctCheck pointIs the power cord loose?Is the power ON ( | ) to the printer?Is the printer cable appropriate andis it connected properly?Did you connect the printer cableAFTER you turned the power to theprinter ON?Is the printer off-line? (Is the PrinterReady indicator out?)Is the printer cable appropriate andis it connected properly?Is the setting configuration in yourcomputer correct?Is the emulation protocol settingcorrect?ProcedureConnect the power cord securely to a powersource.Turn the main switch to the printer ON ( | ).Be sure to use a compliant printer cable andmake sure it is connected properly.Connect the printer cable BEFORE you turnthe power to the printer ON.Perform the appropriate procedure to lightthe Printer Ready indicator and put theprinter on-line.1 Press the Printer key. The machine willswitch to the printer mode.2 Select the “GO” command and thenpress the Enter key.3 The Printer Ready indicator will light.Be sure to use a compliant printer cable andmake sure it is connected properly.Confirm the settings in the printer driver aswell as in the software application in use.Check the emulation protocol setting.Reference page—44—2, 34——

/ 21

Related manuals for Oce OP30C