Oce TDS100 User Manual

Also see for TDS100: Quick reference guide User manual Quick reference guide

Contents

Oce TDS100 User Manual Manual pdf 36 page image

36 User manualUnderstand message codesIntroductionThe Océ TDS100 displays a message code when the copier is not ready to use.The following table shows a summary of the messages codes, the possiblecause and the action to take.What the message code describesCode Possible cause ActionE 0 ■ The original is jammed ■ Clear the original jam(see ‘Clear an original jam’ onpage 41)■ The media feed stoppedduring a copy job■ Clear the media jam(see ‘Clear a media jam’ onpage 43)■ The red stop key was pushedduring a copy job.■ Clear the original jam(see ‘Clear an original jam’ onpage 41)■ Clear the media jam(see ‘Clear a media jam’ onpage 43)E 1 ■ The manual feed table is open. ■ Open the middle cover andlift the manual feed table(see figure 19 on page 44)E 2 ■ The copy media is too short. ■ Use longer cut sheet mediaE 3 ■ The media is jammed ■ Check the media feed(see ‘Clear a media jam’ onpage 43)■ The cut off strip is notremoved.■ Remove the cut off strip(see ‘Straighten the edge of amedia roll’ on page 34)