Oce VarioPrint 2090 Configuration And Maintenance Manual

Also see for VarioPrint 2090: Function guide Safety manual User manual

Contents

Printer configuration 69Note: To activate the new IP settings you must restart the Océ VarioPrint 2090.When to do■ Before you try to print, make sure that you complete these TCP/IP settingsto connect to the Océ VarioPrint 2090 to the network.Before you beginStart the Océ VarioPrint 2090 Settings Editor in your web browser in thesystem administrator mode (see ‘Access the Océ VarioPrint 2090 SettingsEditor in system administrator mode’ on page 12).Attention: If you change any of the settings above, you can only access theOcé Smart Imager through these new settings. If you make the wrongsettings, you cannot reach the Océ VarioPrint 2090 on the network (youcannot start the Océ VarioPrint 2090 Settings Editor). You have to call forservice.Attention: If you change the TCP/IP settings, you must restart the OcéVarioPrint 2090 to activate the new settings. If you do not complete allTCP/IP settings before this restart, you cannot reach the Océ VarioPrint2090 on the network (you cannot start the Océ VarioPrint 2090 SettingsEditor). You have to call for service.IP address The physical address of the Océ Smart Imager connectedto the TCP/IP network.The Océ Smart Imager must have a unique IP addresswithin your network.The IP address has four sets of numbers separated byperiods. Default IP address is 192.1.1.1Subnet mask A method to divide the networks into smaller groups, orsubnets (segments).The mask is a binary pattern that matches the IP address.The Océ Smart Imager compares the subnet mask with anetwork address number. Default value is 255.255.255.0Default gateway The physical address on this subnet of the defaultgateway connected to the TCP/IP network. Default valueis 192.1.1.2Identification setting