Oceanic Vision Series Manual
                     | |
S auna & SteamOceanic Saunas 01902 450 550 sales@oceanic-saunas.co.uk1115. Internal Trim (Fix in this order)i. Cornice (convex)(Mitre cuts if preferred)ii. Skirtiii. Corner Trim (concave)iv. Overlap Mould (fix over every joint between glass and wooden panels as shown)Measure cut and fix the pieces on using 25 or 35mm brads. (Optionally fill holes, then sand down whenfiller is dry)16. Bench AssemblyImportant Safety Information.The benches may have to support the body weight of several bathers. It is important that they arecorrectly assembled; the holes for all screws must be predrilled to prevent the timber splitting. Totighten the screws use a hand held screwdriver or an electrically operated one with a torque settingthat allows the screw to be fully tightened but not to spin as spinning reduces the holding power ofthe screw.Note the use of a good quality PVA adhesive (not supplied) will improve the durability of thebenches.Maximum loadings;Up to 1200 mm no centre support 2 x 12.5 stone peopleUp to 1800 mm with 1 extra support 3 x 12.5 stones peopleBefore commencing the construction of the benches find the specification sheet for the sauna youare building. This will give detail of the correct quantities and positions of timbers and fixings.Vision Sauna Manual |
Related manuals for Oceanic Vision Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine