7 - EnglishMaterial Safety Data Sheet(MSDS N° 58376901)for B710/B720/B730 Series Drum/TonerCartridges52123601 (B710), 52123602 (B720),52123603 (B730)For more information, contact Oki Data at: 2000 BishopsGate Boulevard, Mount Laurel, NJ 08054-4620.Emergency Information (US and Canada only): call1-800-654-3282.Emergency First Aid ProceduresToner swallowed (ingested).Rinse out mouth with water and give several glasses ofwater to drink. Seek medical attention.Toner inhaled.Remove person to fresh air. Rinse mouth with water.Toner gets in the eyes.Flush eyes with large quantities of cool water for 15minutes, keeping the eyelids open with fingers. Seekmedical attention.Toner gets on the skin.Wash toner off the skin with plenty of cool water and soap.Note: Small amounts of toner on skin or clothing caneasily be removed with soap and cold water.Hot water makes toner harder to remove.Hazardous IngredientsPolyester (40-50% by weight)CAS#: Not availableOSHA PEL: Not available.Iron Oxide (40-50% by weight)CAS#: 1309-38-2OSHA PEL: Not available.Amorphous Silica (1-5% by weight)CAS#: Not availableOSHA PEL: Not available.Ethylene/Propylene Copolymer (<5% byweight)CAS#: Not availableOSHA PEL: Not available.Titanium Dioxide (<1% by weight)CAS#: Not availableOSHA PEL: Not available.Physical DataPhysical State: SolidMelting/Freezing Point: Not availableBoiling Point: Not applicablepH: Not available.Vapor Pressure: Not applicableVapor Density (Air=1): Not applicableEvaporation Rate (Butyl Acetate=1): Not availableSpecific Gravity (H 2 O=1): Not availableSolubility in Water: NegligibleSolubility in Solvents: Not availableCoefficient of Water/Oil Distribution: Not availableAppearance and Odor: Black powder, faint odorOdor Threshold: Not availableFire and Explosion Hazard DataFlash Point (O°C): Not applicable.Flammability: Not flammable under conditions of use.Flammable LimitsLower Explosive Limit: Not applicableUpper Explosive Limit: Not applicableAuto-ignition Temperature: Not applicableExplosion DataLike most organic materials in powder form, the toner canform explosive mixtures when dispersed in air.Sensitivity to Mechanical Impact: Not availableSensitivity to Static Discharge: Not available.Extinguishing Media: Water spray, foam, dry chemicals.Special Fire Fighting Procedures: In case of fire, useextinguishing media. When mounted in the printer, treat asan electrical fire.Hazardous Combustion Products: Not applicableToxicological PropertiesRoutes of Entry: Inhalation, Ingestion, Eyes, SkinEffects of Acute Exposure (based on toxicity data forsimilar materials and ingredients):Swallowed LD50 (rat): > 5.0 g/kgSkin LD50 (rabbit): > 5.0 g/kgInhaled LC50 (rat): > 5 mg/L/4hrEffects of Chronic Exposure (based on toxicity data forsimilar materials and ingredients): The results obtainedfrom a sponsored, Chronic Toner Inhalation Study,demonstrated no lung change in rats for the lowest (1 mg/m3) exposure level (i.e. the level most relevant topotential human exposure).A very slight degree of fibrosis was noted in 25% of theanimals at the middle (4 mg/m3) exposure level, while aslight degree of fibrosis was noted in all the animals at thehighest (16 mg/m3) exposure level.These findings are attributed to "lung overloading," ageneric response to excessive amounts of any dustretained in the lungs for a prolonged period. This studywas conducted using a special test toner to comply withEPA testing protocol. The test toner was ten times morerespirable than commercially available Oki toner, andwould not be functionally suitable for Oki equipment.Exposure Limits, ACGIH TLV†:Total: 10 mg/m3Respirable: 3 mg/m3Irritancy: Not an irritant.†Sensitization (skin, guinea pig): Not a sensitizer.†Carcinogenicity: Not classified as “Carcinogens”†IARC: Refer to IARC Monographs on the EvaluationCarcinogenic Risks to Humans (WHO InternationalAgency for Research on cancer).NTP: Refer to National Toxicology Program (NTP)Report on Carcinogens (NTP).OSHA: Not available._____________________________†Based on toxicity data for similar materials andingredients.