42049001TH Rev.1 28 /Oki Data CONFIDENTIAL2.2.12 Low Voltage Power Unit / FAN (ID) / FAN (PowL) / Hopping Motor / Fuser Motor(1) Remove the print controller PWB (see section 2.2.8).(2) Remove the controller PWB (see section 2.2.7).(3) Remove the film 1 and the frame duct 2 to demount the FAN (ID) 3.(4) Remove the two screws 4 and the four connectors to demount the POW unit 5.(5) Demount the FAN (PowL) 6 by releasing claw engagement.(6) Remove the two screws 7 and the connector to detach the hopping motor 8.(7) Remove the two screws 9 and the connector to detach the fuser motor 0.Note! When reassembling the FAN (PowL) 6, check the attachment direction.Figure 2-2-12 Low voltage Power Unit / FAN (ID) / FAN (PowL) / Hopping Motor / Fuser Motor68 795 13024Airwww.eManualpro.com
