Oki C711 Maintenance Manual

Also see for C711 Series: Installation guide Installation guide Security guide User guide Setup guide

Contents

Oki C711 Maintenance Manual Manual pdf 34 page image

44205401TH Rev.1 34 /Oki Data CONFIDENTIAL 3. Set up• Do not set it in any high-temperature locations or near any heat sources.• Do not set it in a place where the chemical reaction may occur (laboratory etc.).• Do not set it near any liquid that may ignite such as alcohol and thinner.• Do not keep it out of reach of children.• Do not place it on an unstable or uneven surface(unstable table and slanting place, etc.).• Do not put it in direct sunshine. And do not put it in a moist or dusty place.• Do not set it in wet or corrosive environment.• Do not set it in a place where may cause vibration.• If the printer is dropped down or the cover is damaged, please pull out the powerplug from the outlet and contact the customer center.This may cause an electric shock, fire, injury.• Please read this manual carefully before connecting the power supply cable, printercable, ground cable.This may cause fire.• Do not insert any foreign objects into the vent hole.This may cause an electric shock, fire, injury.• Do not put a vessel(s) filled with water on the printer.This may cause an electric shock, fire.• Do not touch the fuser unit when you open the cover of the printer.It is hot and could cause burns.• Do not throw the toner cartridge, the image drum cartridge into the fire.It may cause burns due to dust explosion.• Do not use inflammable sprays near the printer.It may cause fire because some parts in the printer may become very hot.• If the cover becomes abnormally hot, smoke rises, it smells strange or it soundsabnormal, please pull out the power plug from the outlet and contact the customercenter.It may cause fire.• If the liquid such as water enters the printer, please pull out the power plug from theoutlet and contact the customer center.It may cause fire.• If you drop the foreign objects such as clip in the printer, please pull out the powerplug from the outlet and take the foreign objects out.This may cause an electric shock, fire, injury.• Do not disassemble the printer unless following the correct procedure written in themanual.This may cause an electric shock, fire, injury.• Do not set it in a place where the vent hole of the printer is blocked.• Do not set it directly on heavy wool or shag carpet.• Do not place it in locations of poor ventilation such as enclosed areas.• Give particular attention to adequate ventilation care when using it continuously in anarrow room for a long time.• Do not place it close to strong magnetic fields and noise source.• Do not place it next to the monitor and television.• Hold tightly the both sides of the printer when you move the printer.• Because the weight of the printer is approximately 33kg (in a state of packing), itneeds more than two adults to lift it up.• Do not come close to the paper exit part while printing.This may cause injury.Please explain the safety precautions about installation and handling with showing theall precautions in user's manual to customer. Especially, the details about power supplycable and the ground cable must be explained completely.3.1 Notes and precautions