41955801TH Rev.8 161 /Oki Data CONFIDENTIALAPPENDIX C C7100/7300/7350/9300/9500 SERIES ERROR MESSAGES1. C7100/7300/7350/9300/9500 Series (Error messages)(Caution) * : Raise in the factory mode only.** : Not raise in the standard config machines.LEDAttenBlinkBlinkBlinkBlinkBlinkBlinkBlinkBlinkBlinkBlinkBlinkBlinkBlinkBlinkBlinkLCD MessagesPOWER OFF/ON300:NETWORK ERRORCLOSE COVER310:UPPER COVER OPENCLOSE COVER311:SIDE COVER OPENCLOSE COVER311:SIDE COVER OPENCLOSE COVER312:TRAY2 COVER OPENCLOSE COVER313:TRAY3 COVER OPENCLOSE COVER314:TRAY4 COVER OPENCLOSE COVER315:TRAY5 COVER OPENCHECK FUSER UNIT320:FUSER UNIT MISSINGPOWER OFF AND WAIT FORA WHILE321:MOTOR OVERHEATOPEN AND CLOSE COVER323:PAPER THICK ERROROPEN AND CLOSE COVER324:PAPER THICK ERROROPEN AND CLOSE COVER325:PAPER THICK ERROROPEN AND CLOSE COVER326:PAPER THICK ERRORDOWNLOAD CHIP DATA327:DENSITY CALIBRATIONCHIP ERRORErrCode300310311311312313314315320321323324325326327*DescriptionA network error is occurring.The cover is open.The cover is open.(PX711)The cover is open.(PX713)The cover is open.The cover is open.The cover is open.The cover is open.The fuser unit is not correctly installedMotor (Driver LSD) overheat errorA Sensor output at Medea Empty isoutside the spec.(factory mode onlyraise)The difference among Sensor outputs isoutside the spec.(factory mode onlyraise)Media detected values are outside thespec.Media detected values in U-HeavyMode are outside the spec.Density Adjustment’s calibration chipcorrection errorOmission of factorydefault setting. To prevent settingmistake.Error that does not occur atuser level.Displayed only in FactoryMode.LEDReadyOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFCommentsAnomalieswith MediaWeightDetectionsensor.
