41955801TH Rev.8 72 /Oki Data CONFIDENTIAL3. ADJUSTMENTThis device is adjusted by key input from the operator panel.Other than the general menu, this device supports a maintenance menu. Select the menu thatmatches your objective.3.0 System Maintenance MENUThe printer enters this mode when you turn on the power supply switch while holding down the[Menu]+[Item]+[Value]+[Cancel] (0+1+6+7)switches.Note: This menu is not disclosed to end-users because changes can be made to brand/destination, etc.Table 3-0 (1/2) Maintenance Menu display TableItem(1st Line)OKIUSERENGINE SPEEDHIGH RESOLUTIONENG STATUS PRINTTEST PRINT MENUPAGE CNT PRINTPCLIBM PPR III XLEPSON FXAdobe PostscriptHP-GL/2PCL XLPDFValue(2nd Line)ODAOELAPSJP1JPOEM1OEMAOEMLHIGHLOWENABLEDISABLEEXECUTEENABLEDISABLEENABLEDISABLEENABLEDISABLEENABLEDISABLEENABLEDISABLEENABLEDISABLEENABLEDISABLEENABLEDISABLEENABLEDISABLEFunctionsSets BrandJPOEM1: Japan OEMOEMA: Overseas OEM for A4 defaultOEML: Overseas OEM for Letter defaultBoots up automatically when the Menu is existed.For swithing the engine speed between theoverseas 16/24PPM model and the 20/24PPM,24/26PPM model.(Valid only for PX711 600dpi Head)HIGH: 20/24PPM model (C7300), 24/26PPMmodel (C7350).LOW : 16/24PPM model (C7100)Reboots automatically as the menu is exited.note: This function for PX713 is ignored.Not used.note: Don’t change the setting value.Selecting by the Select switch, thenpressing the On-line switch will promptinitialization and printing Engine information.Switches ENABLE and DISABLE to display theTEST PRINT MENU category in the User Menu.( See "ID Check Pattern" section. )Sets printing or not printing the total page countin PRINT MENU MAP.Cange the default PDL for each brand.PDLs that are disabled in this Menu will not bedisplayed on User Menu or Adomin Menu’sPERSONALITY.When print data in the PDL language set toDISABLE is received, the printer will displayINVALID DATA and discard received data. (HP-GL/2 is under development, and there is no planto implement as yet in the product. )The PDF function requires Adobe Postscript;thus, switching ON/OFF of PDF alone isdisabled.(Setting Adobe Postscript on DISABLE will setthe PDF function to DISABLE as well. )On the PX711/713, neither Adobe Postscript norPDF can be set to DISABLE. (They are to bealways set to ENABLE for use. Even if they areset to DISABLE, the printer processes the data itreceives. This item is incorporated only in themenu ahead of time for future extension. )DF************CategoryOKIUSERCONFIGURATIONMENUENG STATUS PRINTTEST PRINT MENUPAGE CNT PRINTPERSONALITY
