Oki CX3535MFP Safety Information Manual

Contents

Oki CX3535MFP Safety Information Manual Manual pdf 8 page image

8 - EnglishMaterial Safety Data Sheet# 58409301Cyan Toner, Type D2: P/N 44947307For more information, contact Oki Data at: 2000Bishops Gate Boulevard, Mount Laurel, NJ 08054-4620.Emergency Information: call 1-800-654-3282; US andCanada only.COMPOSITION/INFORMATION ONINGREDIENTSINGREDIENT(S) CAS No. wt.%Polyester resin — 80-90Organic Pigment — <10Wax — <10Amorphous Silica 7631-86-9 <5Titanium dioxide 13463-67-7 <2— TRADE SECRETHAZARDS IDENTIFICATIONEmergency Overview : If used as intended, the product doesnot present acute or chronic health hazard.Physical Hazards : This product is not classified as flammableor combustible. It will burn in case of fire.Avoid contact with strong oxidizers such as chromate, bromateand nitrates.Routes of Exposure : Inhalation, dermal contact, incidentalingestionInhalation : Excessive inhalation may cause irritation of thenose, throat and respiratory tract.Eye Contact : Non-irritant.Dermal Contact : Non-irritant, non-sensitiser.Ingestion : Not currently known.Chronic Effects : See Section 11 Supplemental HealthInformation.Carcinogenicity : See Section 11 Supplemental HealthInformation.Reproductive/Developmental : Not identified.Target Organs : Prolonged breathing of high concentrationsmay cause adverse effects on the respiratory system.Signs and Symptoms of Exposure : Prolonged exposure todusts of this product may irritate the respiratory system.Medical Conditions Aggravated by Exposure to ThisProduct : Respiratory disorders, such as asthma, may beaggravated by prolonged exposure to high concentrations of thisproduct.FIRST AID MEASURESEye Contact : Immediately flush eyes with plenty of water for atleast 15 minutes. If irritation persists, call a physician.Skin Contact : Wash with soap and water. Wash clothing beforereuse. If irritation occurs or is persistent, seek medical attention.Ingestion : Dilute stomach contents with several glasses ofwater.Inhalation : Remove from exposure area to fresh airimmediately. Contact a physician if there is any difficulty inbreathing or other signs of distress.FIRE FIGHTING MEASURESGeneral Hazard : Product will burn in case of fire.Flash Point : Not applicableFlammable Limits : Not applicableAutoignition Temperature : Not applicableFlammability classification : Not applicableExtinguishing Media : Foam, halon, carbon dioxide, drychemical & water fog.Unusual Fire & Explosion Hazard : Combustible powder. Dustof this product at sufficient concentrations can form explosivemixtures with air.Fire Fighting Procedures : NoneHazardous Combustion Products : Carbon monoxide, carbondioxide and smoke.ACCIDENTAL RELEASE MEASURESSpills or Leaks : Vacuum-clean spilled toner and carefullytransfer into sealable waste container. If no vacuum-cleaner isavailable, sweep slowly to minimize generation of dust duringclean-up. Residue can be removed with soap and cold water.HANDLING AND STORAGEHandling : Avoid dust, keep away from ignition sources.Prevention of Fire and Explosion : This material is capable ofcreating a dust explosion. Keep away from heat, sparks & flame.Storage : Keep container in cool and dry area.Hygienic Practices : Avoid inhalation and ingestion. Avoidgetting in eyes, on skin or clothing. Wash hands thoroughly afterhandling, and before eating, drinking, or smoking.EXPOSURE CONTROLS/PERSONALPROTECTIONExposure LimitsOSHA PELs (TWA) as the product : 15mg/m3 (Total dust)5mg/m3 (Respirable fraction)Other substances : Not listedACGIH TLVs (TWA) as the product : 10mg/m3 (Total dust)3mg/m3 (Respirable fraction)Other substances : Not listedDFG-MAK (TWA) as the product : 4mg/m3 (Inhalable fraction)1.5mg/m3 (Respirable fraction)All substances : Not listedNOHSC (TWA) All substances : Not listedEngineering Controls : Maintain adequate ventilation.Eye Protection : Not required under intended use.Skin Protection : Not required under intended use.Respiratory Protection : Not required under intended use.PHYSICAL AND CHEMICAL PROPERTIESAppearance : Fine solid powderColor : CyanScent : OdorlessMelting Point : 110 - 150 degree (Softening point)Specific Gravity(H2O=1) : 1.1 - 1.5Vapor Pressure : Not applicableVapor Density (Air=1) : Not applicableEvaporation Rate : Not applicableSolubility in Water : NegligiblepH Value : Not a water-based product, therefore not applicable.