Oki ES5442 Advanced Manual

Also see for C542: User manual User manual Advanced manual User manual

- 132 -5. Operating Management/ Specifications• Default Mode• Operation Clear• Sound Control• Local Interface*1• System Setup• Power SaveManage UnitItem FactorydefaultsettingDescriptionDefault Mode Home Sets the default mode screen of this machine.Item FactorydefaultsettingDescriptionOperation Timeout 3 Sets time for automatic reset of screen to begin.Available range: 1 to 10 minutesClear After Job OFF Sets whether to reset after job is completed.Item FactorydefaultsettingDescriptionKey Touch Tone Volume Middle Sets the volume of the key-touch tone.JAM Buzzer Volume Middle Sets the volume for the paper jam alert tone.AirPrint Buzzer Volume Low Sets the AirPrint confirmation operation sound.Item FactorydefaultsettingDescriptionUSB Menu Soft Reset Disable Sets whether to enable the soft reset command.Speed 480Mpbs Selects the maximum transfer speed of USB interface.Offline Receive Disable Set whether to receive data in offline state or in recoverableerror state.Serial Number Enable Sets whether to use a USB serial number.ConnectedHostNormal Sets a host to be connected.Item FactorydefaultsettingDescriptionAccess Control Disable Sets access control.Default Authent. Method Sett. Local Name Available only when [Access Control] is set to [Enable].Unit of Measure Millimeter orInchSelects a displayed unit (millimeter / inch).Default Paper Size A4 or Letter Sets the default paper size.Date Format dd/mm/yyyy ormm/dd/yyyySets the date format.Allow All Reports To Print Disable Sets whether to allow printing reports with personalinformation.Near Life LED Enable Sets whether to light an LED if a near life warning occurs.Status in Near Life Enable Sets whether to display a message if a near life warningoccurs.USB Memory Interface Enable If [Disable] is set, the print from USB Memory function cannotbe used.Panel Brightness DuringOperating7 Sets the LCD panel brightness.Available range: 1 to 7 (1 increments)Panel Brightness While PowerSave0 Sets the LCD panel brightness.Available range: 0 to 7 (1 increments)Panel Calibration Execute Executes LCD panel calibration.Item FactorydefaultsettingDescriptionPower Save Time 1 minute Sets when to enter Power Save mode.Sleep Time 15 minutes Sets when to enter Sleep mode.Auto Power Off Time 4 hours Sets when to enter Auto Power Off.Silent Mode ON Specifies a print preparation operation when entering standbystatus from Sleep mode.If [ON] is set: it is quiet as there is no print preparation.If [OFF] is set: there is a rotation noise of the image to performprint preparation but you can start first printing early.ECO Mode*1 ON If [ON] is set: Printing starts even before the temperature of thefuser reaches the prescribed degrees, if the job is small.If [OFF] is set: Printing starts after the temperature of the fuserreaches the prescribed degrees.