- 13 -Installing Your Machine1 Machine Setup●● Installing Your MachineThis section explains how to unpack and install the machine.Installation RequirementsThis section explains the required environmentand space for machine installation.Installation EnvironmentYour machine must be installed in the followingenvironment:Temperature: 10°C~32°CHumidity: 20%~80% RH (relativehumidity)Maximum wet bulbtemperature: 25°CNote● Be careful of condensation. It may cause a malfunction.● If installing your machine where the relative humidity ofthe surrounding air is less than 30%, use a humidifier orantistatic mat.WARNING● Do not place in hot locations or near fire.● Do not install in locations where chemicalreactions take place (laboratory etc.).● Do not place in locations near flammable solutionssuch as alcohol and thinner.● Do not place in locations within reach of smallchildren.● Do not install in unstable locations (wobbly stand,angled place, etc.).● Do not install in locations with high humidity ordust and where exposed to direct sunlight.● Do not install in an environment exposed to brinyair and corrosive gas.● Do not install in locationss with much vibration.● Do not install in locations where the ventilationholes of the machine are blocked.CAUTION● Do not place directly on a rug or carpet with longstrands.● Do not install in a closed room with poorventilation or circulation.● If you use the machine in a small room for a longtime, please make sure that you ventilate theroom.● Install away from strong magnetic fields andsources of noise.● Install away from monitors or TVs.● When moving the machine, hold it on both sides,and move it by slightly tilting the back down.Installation SpaceInstall your machine on a flat surface that iswide enough to accommodate the machine.Allow for enough room around your machineaccording to the images below.● Top view100cm20cm20cm60cm● Side view60cm