Oki MC361 Service & Troubleshooting Manual

Also see for CX2731MFP: Replacement instructions User guide Advance user guide Manual Quick start guide

Oki MC361 Service & Troubleshooting Manual Manual pdf 12 page image

12Menu Item 1 Item 2 Item 3Service BitCountry CodeTone Send TestDP Send TestMF Send TestLine TestModem Signal SendTestFaxMaintenance*This menu not shownon models with no fax.T.30 Monitor ExecuteIBM 5577IBM PPR III XLPersonalityEPSON FXPrint MaintenanceEngine Diag Mode2.3 System MaintenanceOKIUSERSets the MFP for the Destination Country.Note! Should always be set for ODA (North America). Settings other than ODA mayresult in erratic MFP operation. When the screen exits the service menu after this settingis changed, the MFP reboots automatically.Format SD CardA confirmation message is displayed when the Enter switch is pressed.When "No" has been selected, the system returns to the previous menu.When "Yes" has been selected, the menu is exited and formatting of the inserted SD cardbegins.Displayed under the following conditions:SD card inserted ("Boot Menu" - "Storage Setup" - "Enable SD Card" is Yes)Format Flash ROMCaution! Use of this command is strictly prohibited (contact design before use).When this command is executed, the menu is exited and formatting of the resident(onboard) flash device begins.Reset Admin PasswordReturns the administrator password to the factory default value.All ResetReturns the content of EEPROM, flash, and the HDD to their factory default values.When this command is executed, the following confirmation message is displayed: "Thischange will reboot the device automatically. Proceed?"When "No" has been selected, the system returns to the previous menu.When "Yes" has been selected, the menu is exited immediately and then, after rebooting,reset processing begins. See the "format scope" sheet for the scope of formatting.