Oki MICROLINE 8810 Setup Manual

Also see for ML8810: User guide Installation instructions Brochure Safety & warranty Hardware installation instructions

Contents

Oki MICROLINE 8810 Setup Manual Manual pdf 10 page image

108. Position the continuous forms stack below theprinter with no more than about 1 inch (3 cm)offset (1).Tearing Off Printed Continuous Forms9. With the SEL light on, press SHIFT.The continuous forms move forward onto thestacker.10. Tear off the printed form along the perforation.11. Press SHIFT.The forms move back into the printer, ready forprinting the next document.Removing Continuous Forms1. Follow the steps above to remove the printedportion.2. Press SEL.3. Press LOAD.The forms move back to the tractors.4. Lift the platform and remove the forms from thetractors.5. Lower the platform.Step 5:Connect to the ComputerCaution!Do not connect both the USB and parallelports at the same time.USB PortNoteNo USB interface cable is supplied with theprinter. Use a USB cable that is compatible withUSB specification 2.0.1. Turn off the printer.2. Connect the USB cable to the USB port on theprinter.3. Secure the cable in one of the channels (1)molded into the housing on either side at the backof the printer to keep it out of the way.4. Connect the USB cable to the USB port on thecomputer.5. Turn on the printer.F5-08a.jpgF5-09.jpgF3_02_crop.jpgF1_24c.jpgusb_pc.jpg