Oki MICROLINE 8810 Setup Manual

Also see for ML8810: User guide Installation instructions Brochure Safety & warranty Hardware installation instructions

Contents

Oki MICROLINE 8810 Setup Manual Manual pdf 7 page image

7Step 3:Run a Self TestBefore proceeding, run a self test to check that theprinter is operating correctly. This prints out a list ofavailable fonts.1. Turn off the printer.2. Press and hold MODE and LF whileturning on the printer. Release themwhen RELEASE SW appears on thesecond line of the display.3. When the printer finishes initializing,the display will prompt you to insertpaper.4. Place a letter size or larger sheet of paper on theplatform anywhere within the ìPaper range whenAuto Align is ONî area.The sheet feeds in. The test prints and the page isejected back out onto the platform.The self test is complete.Step 4:Load PaperIndividual Sheets/Forms (ìMANUALî)The printer is set at the factory forï single sheets/forms (Manual Feed)ï Auto Align modeï automatic printhead gap (Auto Gap)8810 MODE + LF.jpgF5-11a.jpgPaper Specifications,for Use with Auto Align ModeMinimum Print Margins1/4-inch (6.4 mm) on all sidesIndividual Sheetsï Sizeñ Minimum Width: 3.9î (100 mm)ñ Maximum Width: 14.3î (364 mm)ñ Minimum Length: 2.8î (70 mm)ñ Maximum Length: 16.5î (420 mm)ï Weightñ Minimum:13.8 lb. US Bond (52 g/m 2)ñ Maximum: 55.8 lb. US Bond (210 g/m 2)Individual Multi-Part Formsï Sizeñ Minimum Width: 3.9î (100 mm)ñ Maximum Width: 14.3î (364 mm)ñ Minimum Length: 2.75î (70 mm)ñ Maximum Length: 16.5î (420 mm)ï Thicknessñ Up to 8-part forms (original + 7)ñ Maximum Thickness: 0.0189î (0.48 mm)