Set Up7EnglishNote 1:When using a paper width of less than 127 mm for thefront feed and 102 mm for the rear feed, remove oneof the paper supports from between the tractors. Thisis a push fit onto the supporting rods.Note 2:Refer to Controls & Indicators in Operation forlocation of the buttons mentioned below.Front Paper Feed Loading1. Open the front cover, then open the tractor covers and lift up thetractor lock levers.2. Move the right tractor to approximately fit the width of paper beingused.3. Place the first three holes in the paper over the tractor pins at eachside and close the tractor covers.4. Move the left tractor to align the edge of the paper with theappropriate reference mark, then lock the tractor in place bypressing down the lock lever.5. Move the right tractor to centre the paper holes on the pins and lockthe tractor in place by pressing down the lock lever.6. Select the paper feed path on the printer.7. Press FF/LOAD button and the paper feeds into the printer from theselected paper path.Rear Paper Feed Loading1. Open the rear cover, then open the tractor covers and lift up thetractor lock levers.2. Move the left tractor to approximately fit the width of paper beingused.