OF5750/5950 Series January 2001 1 - 541.6.7 G3 Protocol DumpPurpose:To allow the serviceman to obtain a list of protocol signals transferred between the transmitterand receiver.Method:The report will be manually printed out for maintenance purpose. If the previous communica-tion is G3, G3 communication protocol dump is printed out. If it is G4, the G4 communicationprotocol dump is printed.1. Title of the report2. Date and time when the report was printed3. Sender ID4. Date of communication5. Time of communication6. One message transmission/reception time7. Identification of remote station * CSI and/or telephone number8. Mode of transmission/reception according to ITU-T designation9. Total number of pages in communication10. Identification of the result of the communication11. Service code12. TX: DIS/DTC/DCS/NSF/NSS/NSC13. Transmitted telephone number14. Transmitted SEP/SUB15. Transmitted SID16. Common information of ITU-T V.34 TX/RX17. Modem trace18. RX: DIS/DTC/DCS/NSF/NSS/NSC (page2)19. Received telephone number (page2)20. Received SEP/SUB (page2)21. Received SID22. Common information of ITU-T V.34 TX/RX (page2)23. Modem trace (page2)1.6.7.1 Difference from OKIFAX5700/5900(1) When G3 option is installed, manually output protocol dump (4 sheets) of the main linecommunication and optional line communication.(2) If communication error or page re-transmission occurs (that is same as the error MCFoutput condition), automatically output erroneous communication protocol dump (byhidden setting ON-OFF).(3) Add or change the following descriptive formats:Change Transmitted-DIS from 13 bytes to 20 bytes of descriptionsChange Transmitted-DTC from 13 bytes to 20 bytes of descriptionsChange Transmitted-DCS from 13 bytes to 20 bytes of descriptionsChange Transmitted-NSF from 60 bytes to 100 bytes of descriptionsChange Transmitted-NSC from 60 bytes to 100 bytes of descriptionsAdd Transmitted-SID frame descriptions (23 bytes).Change Received-NSF from 70 bytes to 100 bytes of descriptionChange Received-NSC from 70 bytes to 100 bytes of descriptionAdd Received-SID frame descriptions (23 bytes)Describe “#” symbol to the descriptions of information on the result of communication forcommunication using G3 option. (see 1.6.11 “Activity Report”)
