Page: 40Service Guide OKIPAGE 10eChapter 3 Disassembly3.3.15 Fusing Unit(1) Remove the upper cover assy (see 3.3.1).(2) Remove the operator panel assy (see 3.3.4).(3) Remove the face up stacker assy (see 3.3.8).(4) Remove the lower base unit (see 3.3.12).(5) Remove the four screws (1), lift and remove the fusing unit (2).Caution: Fusing unit may be hot. Use care when handling.Notes:1. When reinstalling or removing the fusing unit, tighten or loosen the screws while holding the fusing unit assy (2) downwith your hand (it is being pushed up by back up roller).2. When reinstalling the screws (1), be sure to direct the screws into preexisting thread and avoid damaging the threads.3. Do not apply excessive torque when tightening the screws (1).
