Page: 18Service Manual - OKIPAGE10iChapter 2 Operation DescriptionThe paper jam detection function monitors the paper condition when the power is turned on and duringprinting. When any of the following conditions arises, this function interrupts the printing process. If any ofthe following errors is encountered, printing can be recovered by removing the jammed paper (by openingthe upper cover, removing the jammed paper and closing the upper cover).Error Cause of errorPaper Input jam The paper is in contact with the inlet sensor when thepower is turned on.After hopping operation is attempted three times, theleading edge of the paper does not reachthe inlet sensor.Paper feed jam The paper is in contact with the paper sensor when thepower is turned on.The leading edge of the paper does not reach thepaper sensor within a predetermined feedingdistance since the paper has reached the inlet sensor.The trailing edge of the paper does not pass over thepaper sensor within a predetermined feeding distanceafter the same has passed over the inlet sensor.The leading edge of paper does not reach the outletsensor within a predetermined feedingdistance after the paper has reached the paper sensor.Paper exit jam The paper is in contact with the outlet sensor when thepower is turned on.The paper does not pass over the outlet sensor within apredetermined feeding distance after the leading edgeof the paper has reached the outlet sensor.The paper size check for manual feeding finds that thepaper size is free size.Paper size error The size of the paper is monitored by the inlet sensor 1.The paper is not detected by the inlet sensor 1 withinpredetermined feeding distance.The inlet sensor 2 detects that the size of the loadedpaper is A4 or larger, or smaller than A4. The detectedpaper size differs from the paper size set by commandor menu.The paper size check for manual feeding finds that thepaper size is free size.