Page: 166Service Guide OKIPAGE 24DX/24DXnChapter D Second / Third Paper Feeder Maint (option)2.1 Driving MechanismThe high-capacity second/ third paper feeder only a top paper which is set in the cassette by a signal from theprinter.(1) Second paper feeder as an example is shown. First of all, the hopping motor rotates in the direction of arrow A.Roller C rotates by way of idle gear on the same shaft on which the hopping gear is placed. At the same time, theplanetary gear D shifts in the direction of arrow E and a sub roller gear and a sub roller on the same shaft rotate.Roller C and sub roller make a paper hop. Also, the planetary gear G shifts in the direction of arrow H and Roller Krotates, and when the length of sheet is legal 13 inch or more, a hopping paper will be impinged to the regist rollerwithin the printer. When the length of paper is A4 or less, hopping papers will be carried until the defined amount.(2) When the length of paper is A4 or less, the hopping roller rotates in the direction of arrow B next. At this time, theplanetary gear G shifts in the direction of arrow I to rotate Roller K and impinge the papers, which are carried to thedefined amount, to the regist roller within the printer. During the hopping roller is rotating, Roller C is racing becauseit includes one-way bearing. At the same time, planetary gear D shifts in the direction of arrow F and the sub rollergear and another sub roller on the same shaft won't rotate.(3) In the third paper feeder, when the length of paper is legal 13 inch or more, and if the rotating direction is arrowA', papers will be carried to the defined amount without being impinged to the regist roller, and then the rotatingdirection of the hopping roller will be changed to arrow B'. When the rotating direction of the hopping roller A' arrowdirection, the motion is same as (1). When B' arrow direction, the motion will be same as (2) until Roller K' begin torotate. The planetary gear M' will shift in the direction of arrow L by way of the gear O' which begin to rotate at thesame time when the roller K' does. And gear N rotates, resulting in rotating the gear J and roller K on the same shaft,and impingeing papers to the regist roller within the printer.At this time, as the gear O and gear P engaged by the planetary gear G on the same shaft, on which the gear J androller K are placed, includes an one-way clutch gear, the planetary gear G won't rotate.Impinged papers are, afterwards, fed by the control of printer's inside.
