Oki OKIPOS 426S User Manual

Contents

|18 OKIPOS 426S1..1. Adjusting the Roll Paper Near End Sensing PositionThe paper near end detector detects when the paper is almost gone by measuring the diameter ofthe Roll paper.If you want to change the amount of paper remaining when the printer stops printing, follow thesteps below to adjust the paper near end detector.Note: If the inner diameter of the Roll paper core is more than 26mm (1.02 inch), the Rollpaper near end detector may not work properly.1. Open the printer cover.2 Determine the point on the Roll paper at which you want the near end detector to be triggered.Then measure the distance A shown in the illustration.Note: There may be some difference between the measured distance A and the actualsensing position.3. Find the corresponding adjustment position number from the table below.Distance A Adjustment position number4 mm (0.16") #16 mm (0.24") #28 mm (0.32") #311 mm (0.43") #419 mm (0.75") #526 mm (1.02") #6Note: Above values are applicable when the inside diameter at the core of the Roll paperis 10mm.4. Loosen the detector screw with a coin or screwdriver.5. Set the detector scale to the position you determined from the table by moving the detectorscrew up or down. The numbers #1, #2, #3... are not marked on the detector scale.6. Secure the detector screw; then close the printer cover.Distance A14