2 OKIPAGE 8w Liteplugged into the outlet should not exceed 13amperes.• The power outlet into which the printer is con-nected must remain accessible at all times.• Opening any cover may expose hot surfaces.These are clearly labelled. Do NOT touch them.• Do not insert anything into the ventilation slotson the printer; you could get a shock or cause afire.• Aside from the routine maintenance described inthe user’s guide, do not try to service the printeryourself. Opening a cover may expose you toshocks or other hazards.• Do not make any adjustments other than thoseoutlined in the user’s guide as damage may becaused to the printer.If anything happens that indicates that the printer is notworking properly or has been damaged, disconnect theprinter from the power source and contact your dealer.These are some of the things to look for:• The power cable or plug is frayed or damaged.• Liquid has been spilled into the printer, or it hasbeen exposed to water.• The printer has been dropped, or the cabinet isdamaged.• The printer does not function normally when fol-lowing the operating instructions.Toner cartridge and image drumhandling• Leave unused toner cartridges and image drumunits in their packages until needed. Whenreplacing a toner cartridge or image unit, reusethe packaging to dispose of the old toner cartridgeor image drum unit.• Do not expose the toner cartridges and imagedrum units to light for more than five minutes.Never expose the green drum (inside the imagedrum unit) to direct sunlight.• Always hold the image drum unit by the ends —never by the middle. Never touch the green druminside the image drum unit.• To avoid damage to the image drum unit, alwaysuse original toner cartridges.• Exercise care when removing the toner cartridge.Do not let it touch your clothing or porous mate-rials. The toner powder causes permanent stains.