– 36 –DIP switch 3No. 1 2 3 4 5 6 7 8ONOFFDIP-SW 3The following is the procedure for changing the settings on DIP switch No. 3.1. Turn off the printer and all components connected to it.2. Remove the 2 screws.3. Remove the serial interface board unit.4. Change the setting of the DIP switches.5. Replace the serial interface board unit.Then secure it with the screws.6. Turn on the printer and all components connected to it.The factory settings of DIP switch are all on, except for switches 7 and 8.DIP-SW 3Switch Function ON OFF3-1 Baud Rate See table below3-23-3 Data Length 8 bits 7 bits3-4 Parity Check Disabled Enabled3-5 Parity Odd Even3-6 Handshake DTR/DSR XON/XOFF3-7 Should not be changed (Should be set tooff) — —3-8Baud Rate Switch 3-1 Switch 3-24800BPS OFF ON9600BPS ON ON19200BPS ON OFF38400BPS OFF OFF
