Oki T400 Installation Manual
Also see for T400: Safety informationInstall SheetSetup guideUser guideInstallation
   | |
Contents | 
Page 1Installing the Cutter KitITEM "A"SCREWITEM "B" SCREWSITEM "A"ITEM "B"STEP PROCEDURE1. Switch the printer O and disconnect the power cord.2. Raise the top cover and print head assembly.3. Refer to the illustrations on the following pages.Remove the front door panel.4. Raise the tear bar to the upright position.5. Insert the connector from Item "B" into CN3 on the printer.6. Install Item "B" by placing the tabs in and down into the slots on theprinter. Be sure the positioning holes on Item "B" are inserted on thepositioning pins. Secure with (2) Item "B" screws.7. Lower the tear bar to the operating position.8. Secure Item "A" to the print head with Item "A" screw. Lever on Item"A" swings down to unlock and up to lock and pivots forward in theunlocked position.9. Lower the print head assembly and replace the front door panel and topcover.10. Set the dip switch settings to the cutter mode.1WSD 2WSD 3WSD GNITTESffO nO ffO edoMrettuC |
Related manuals for Oki T400
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine