Operation Manual ConfigurationCT400/410 213.2 DIP-SW SettingsAppropriate settings are made according to your printer environ-ment. However, if there is a setting error, you must change the set-ting by using DIP-SW. Please read the following instructionscarefully before you change the settings.1. Make sure the power of the printer is OFF.2. Open the front cover of the printer.Caution: There is a transparent cover over the DIP-SW.Remove this cover when you operate the DIP-SW.After operations are completed, please put thiscover back on.3. Switch ON or OFF for each DIP-SW according to the setting.DIP-SW 1,2 Paper feeding/Download modeDIP-SW 3 Download modeDIP-SW 4 Print methodDIP-SW 5 Head checkDIP-SW 6 VR1 settingDIP-SW 7 Data dump functionThe position of the DIP-SW is set according to the system config-uration required.