Oki T400 User Manual
Also see for T400: Safety informationInstall SheetSetup guideInstallationInstallation
                                                                  | |
Contents
| 
334.2.2 KitInstalling the CutterSTEP PROCEDURE1. Switch the printer OFF and disconnect the power cord.2. Raise the top cover and print head assembly.3. Refer to the illustrations on the following pages.Remove the front door panel.4. Raise the tear bar to the upright position.5. Insert the connector from Item "B" into CN3 on the printer.6. Install Item "B" by placing the tabs in and down into the slots on theprinter. Be sure the positioning holes on Item "B" are inserted on thepositioning pins. Secure with (2) Item "B" screws.7. Lower the tear bar to the operating position.8. Secure Item "A" to the print head with Item "A" screw. Lever onItem "A" swings down to unlock and up to lock and pivots forward inthe unlocked position.9. Lower the print head assembly and replace the front door panel andtop cover.10. Refer to Section2.1 and set the dip switch settings to the cutter mode. |
Related manuals for Oki T400
manualsdatabase
Your AI-powered manual search engine