5238-E P-235SECTION 9 CONTOUR GENERATIONSECTION 9 CONTOUR GENERATION1. Contour Generation Programming Function (Face)1-1. Function OverviewThe contour generation function can cut straight lines or arcs on the end face of a workpiece bysimultaneous two-axis interpolation of the C- and X-axes on multi-machining models.Note that simultaneous three-axis control of X, Z, and C axes is possible for straight line cutting on aplane.1-2. Programming FormatStraight line cutting : G101 X Z C FX, Z, C : Coordinates of target point on straight lineF : Feedrate (mm/min)Arc cutting : G102 X C L FX, C : Coordinates of end point of clockwise arcL : Arc radiusF : Feedrate (mm/min): G103 X C L FX, C : Coordinates of end point of counterclockwise arcL : Arc radiusF : Feedrate (mm/min)
