Olivetti d-Copia 20 Operation Manual

Contents

CHAPTER 3 HOW TO LOAD PAPER3-321323Adjust the insert guides to the size of the paper to be loaded.NOTE• When loading B4 or larger paper, pull out the support guide.Insert the paper along the guides as far as it will go.IMPORTANT• When loading paper into the multi-bypass, make sure that the copyside is facing downward. (The copy side is the side facing upwardwhen the package is opened.) If the leading edge of the paper iscurled, straighten it out before loading the paper in the multi-bypass. Setting the paper size for the multi-bypassBy setting either the transparency mode or thick paper mode and thepaper size for the multi-bypass, the multi-bypass can be automaticallyselected according to the original size such as when the auto paperselection mode is selected.Press and hold the Paper Select key for 3 seconds. Thescreen to set the paper size and select either the transpar-ency or thick paper mode appears.When using transparencies or thick paper, first select themode by pressing the cursor up or down key and then selectthe paper size.The setting of transparencies or thick paper will be resetwhen the Clear All key is pressed or by the auto clearfunction.When using standard paper or other types of paper, selectthe size from those given below. If "No size designation" isselected, the width will be determined by the position of theinsert guides of the multi-bypass. This size setting will not bereset by the auto clear function. It will be stored for the nextuse.Press the cursor right or cursor left key and select the paperlength, which is shown highlighted. The paper length can beset to any value from 100 to 297 mm in 1 mm increments.BYPASS PAPERSIZE SELECTIONOHP FILMTHICK PAPERNO SIZE DESIGNATIONCUSTOM SIZESA3A4A4RA5RB4B5B5RB6FolioLENGTHWIDTH