5 921468007_09_0102. User instructions2.1. Basic operationsThe panel has 1 main code (master code) which by default is set to [1 2 3 4] and up-to 50 user codeswhich by default are not programmed. The system can operate in two different modes. Depending onthe mode of operation, the arm and disarm operations differ.Complete SystemIn this case the system arms and disarms altogether.Arming can be achieved by using the master code or one of the user codes. The arming of the sys-tem can also be done by simply pressing the ABC key during the installation if the option «ARMWITHOUT CODE» has been selected.Disarming can be achieved by entering the master code or one of the user codes.Split SystemIn this case the system operates as three independent subsystems. You can arm and disarm thewhole system or each subsystem independent from the others.Arming of the whole system can be done by using the master code or one of the user codes thathave been programmed for general arming. The arming of the system can also be done by simplypressing the ABC key if during the programming the option «ARM WITHOUT CODE» has been se-lected.The disarming of the system can be done by using the master code or one of the user code thathave been programmed for general disarming.The individual arming of the subsystems Α, Β, C can be done by pressing one of the user codesthat have been programmed to arm each subsystem. The arming can also be done by pressing one ofthe Α, Β or C keys if during the programming « ARM WITHOUT CODE » has been selected. The arm-ing of one subsystem does not affect the status (armed-disarmed) of the other subsystems.The individual disarming of the subsystems Α, Β, C can be done by pressing one of the usercodes that have been programmed to disarm each subsystem. The arming of one subsystem does notaffect the status (armed-disarmed) of the other subsystems.If during the arming procedure a zone is active then the keyboard shows the message:Which means that on zone 5(kitchen) a window has been left open.If we press (#) the arm command is canceled.If we press (*) or close the kitchen window we see:This message is shown for 1 second and immediately the armingprocess starts.SYSTEM CAN NOT ARMZONE 05KITCHEN*: BYPASS ZONE#: CANCELZONES BYPASSEDREADY TO ARM