Olympus 141932 Instructions Manual

Contents

796TroubleshootingProbable causeThe battery is not loaded properly.The battery is dead.The recorder is in HOLD mode.The recorder is in HOLD mode.The battery is dead.Low remaining internal flash memory.The maximum number of files has beenreached.MUSIC mode is active.The earphone is connected.The VOL(+ or -) button is set to 0.The file is locked.The file is read-only.The recorder was shaken during recording.The recorder was placed near a cell phoneor fluorescent light while recording or duringplayback.The microphone sensitivity is too low.The maximum number of marks has beenreached.The file is locked.The file is read-only.Wrong folder.SymptomNothing appearson the displayWon’t startUnable torecordNo playbacktone heardUnable to eraseNoise heardduring playbackRecording leveltoo lowUnable to setindex marks,tempmarksCannot find therecorded voiceActionVerify polarity is correct.Replace with new battery (☞ P. 12).Release the recorder from HOLD(☞ P. 75).Release the recorder from HOLD(☞ P. 75).Replace with new battery (☞ P. 12).Erase unnecessary files (☞ P. 72).Check another folder.Switch to VOICE mode (☞ P. 14).Unplug the earphones to use theinternal speaker.Adjust the VOL(+ or –) button (☞ P. 30).Unlock the file (☞ P. 40).Cancel the read-only setting of the fileon the PC.Move the recorder.Set the microphone sensitivity to “Conf”mode and try again (☞ P. 25).Erase unnecessary marks (☞ P. 76).Unlock the file (☞ P. 40).Cancel the read-only setting of the fileon the PC.Switch to the right folder.Troubleshooting