Olympus 27MG User Manual

Also see for 27MG: Getting started guide

Contents

Olympus 27MG User Manual Manual pdf 55 page image

DMTA-10043-01EN, Rev. C, July 2016Additional 27MG Gaging Features 47• Hold/Blank• Measure rate• CAL Lock7.6.1 Changing UnitsChanging units allows the user to change from inch measurement units to millimetermeasurement units.To change units1. Press [2 nd F] [] (SETUP) to display the setup tabs.2. Use the [, ] keys to highlight the MEAS tab.3. Use the [] key to highlight UNITS and the [, ] keys to select imperial (IN) ormetric (MM) display units.4. Press [MEAS] to return to measurement mode.7.6.2 Changing ResolutionResolution allows the user to change the number of decimal points displayed in thethickness display.The user can select between STANDARD (0.01 mm [0.001 in.]) and LOW (0.1 mm[0.01 in.]).To change resolution1. Press [2 nd F] [] (SETUP) to display the setup tabs.2. Use the [, ] keys to highlight the MEAS tab.3. Use the [] key to highlight RESOLUTION and the [, ] keys to selectSTANDARD or LOW.4. Press [MEAS] to return to measurement mode.7.6.3 Configuring Min or Max ModeThe Min/Max mode allows the user to put the gage in minimum (MIN) or maximum(MAX) scanning mode. This feature allows the user to scan over an area and quicklydetermine the minimum or maximum thickness.