Troubleshooting16210AppendixHalation produces unnatural colors in the picture.This may be caused byexcessively brightultraviolet light on thesubject, such as sunlightshining through theleaves of trees, windowframes in bright light atnight, reflection of metalin direct sunlight, etc.Use a UV filter. As this may upset the overallcolor balance, it should only be used in theconditions described on the left.If the discoloration persists, touch up thepicture using a graphics application. Fordetails, refer to the manual for the graphicsapplication you are using.–Pictures you have taken do not appear on the monitor.The power is off. Set the mode dial to q, then press thePOWER switch to turn the camera on.P.12The camera is in theshooting mode.Press the QUICK VIEW button or set themode dial to q.P.12, 13There are no pictures onthe card.“NO PICTURE” is displayed on the monitor.Record pictures.–There is a problem withthe card.See “Error codes”. P.156The camera isconnected to a TV.The monitor does not function when the AVcable is connected to the camera.P.96Single-frame erase and all-frame erase cannot be performed.The pictures areprotected.Display pictures with 9 and press the 0button to cancel protection.P.98No picture is displayed on the TV when connected to the camera.The video output signalis incorrect.Set the video output signal according to theregion where used.P.97The TV video signalsetting is incorrect.Set the TV to the video input mode. P.96The monitor is hard to see.The brightness of themonitor is not adjustedproperly.Select [s] in the mode menu and adjust thebrightness.P.114The monitor is exposedto direct sunlight.Block the sunlight with your hand or use theviewfinder.–Possible cause Corrective action Ref.page
