E-132. Advance Check of the CaseAdvance test before useThis Case has been the subject of thorough quality control for theparts during the manufacturing process and thorough functioninspections during the assembly. In addition, a water pressure testis performed with a water pressure tester for all products to confirmthat the performance conforms to the specifications. However,depending on the carrying and storage conditions, the maintenancestatus, etc., the waterproof function may be damaged.Before diving, always perform the following advance test and thewater leakage test after installation of the camera.Advance Test1. Before installing the digital camera in the Case, immerse theempty Case to the intended water depth to confirm that there isno water leakage.2. Main causes of water leakage are as follows. The O-ring has not been installed. A part of the O-ring or the entire O-ring is outside the specifiedgroove. O-ring damage, cracks, deterioration or deformation Sand, fibers, hair or other foreign matter sticking to the O-ring,the O-ring groove or the O-ring contact surface on the front lid Damage to the O-ring groove or the O-ring contact surface onthe front lid When closing the Case, check for catching of the hand strap andsilica gel after the above causes have been eliminated.: • The most suitable method for checking water leakage isto immerse the Case to the intended water depth. Whenthis is difficult, water leakage also can be checked at ashallow depth with no water pressure. Do not feel thatthis is troublesome, but perform this test.• If the advance test should show water leakage withnormal handling, stop using the Case and contactyour dealer or an Olympus service station (listed onthe rear page of this instruction manual).CAUTION