E-5Handling the Product● Use or storage of the product at the following locations may causedefective operation, defects, trouble, damage, fire, internal clouding, orwater leakage. Always avoid these locations. Locations reaching high temperatures such as those under directsunlight, in an automobile, etc. Locations with open fire Water depths in excess of 40 m Locations subject to vibrations Locations with high temperatures and much dust or with severetemperature changes Locations with volatile substances● This product is made of polycarbonate resin with excellent impactresistance, but it may be damaged by scraping against rocks etc. Italso may break when it hits hard objects or is dropped.● This product is not a case to soften impacts to the camera inside theproduct. When this product with a digital camera inside it is subjectedto impacts or heavy objects are placed onto it, the digital camera maybecome damaged. Please handle the product with sufficient care.● When the product is not used for a long time, the waterproofperformance may drop because of deterioration of the O-ring etc.Before use, always perform the advance test and the final check.● Do not apply excessive force to the TTL cable connector or tripodsocket.● When a flash is used while the Case is being used, shadows mayappear at the edges of the picture. This is especially notable whentaking pictures in macro mode on the wide-angle side. Please usea flash after image confirmation.8. When the O-ring contact surface is pressed strongly from theoutside of the Case, or when the Case is twisted, the waterprooffunction may be lost. Take care not to exert excessive force.9. Please use the Case after performing the advance test and thefinal check.10 . If you should notice drops of water or other signs of water leakagewhile taking pictures, immediately stop the dive, remove any waterfrom the camera and the product, test according to the item "Finalcheck", and confirm whether leakage has occurred or not.