EN 34EN2 When the Case is used, left or stored at the following locations,defective operation or trouble may occur. This should beavoided.• Places where the Case can reach high temperature underdirect sunlight or in a car, places with extremely lowtemperature and places with extreme temperature variations• Locations with open fire• Locations with volatile substances• Locations subject to vibrations3 In case of the following handling with a camera loaded into theCase, the Case and/or the loaded camera may malfunction ormay be damaged. This should be avoided.• Hitting other objects• Dropping• Placing heavy objects on top of the Case4 When the Case is not used for a long time, trouble may occurdue to formation of mold. Before use, confirm the operation ofall operation parts and perform the advance test and the finaltest.Q4: What cautions must be observed when opening and closingthe Case?A4: Pay special attention to the following items.1 Do not open and close the Case at locations where there iswater spray or sand.2 Wipe off all waterdrops from the gap between the front lid andthe rear lid and around projections and recesses such as thebuckles. Failure to do so may result in waterdrops in the Casewhen opening.3 When opening the Case, take care that no water will drip fromyour hair or body into the Case or onto the camera.4 When the Case is open, check that no sand, fibers or otherforeign matter is adhered to the O-ring and the O-ring contactsurface on the front lid.5 Do not touch the camera or the image storage with your handswet with sea water.6 If you detect waterdrops or other signs of water leakage whileshooting, immediately end the dive, perform the water leakagetest again, and confirm that there is no leakage. If the camerais wet, wipe off any moisture and check the operation.
