Olympus SP-310/SP350 Instruction Manual

Contents

E-20Insertion of silica gelBefore sealing the Case,insert the accessory silicagel bag (for prevention offogging) between thebottom of the camera andthe Case. Insert the bagwith the glued longer sideto the inside.: • Insert the silica gel all the way at the specifiedlocation and with the specified orientation. When theorientation is not correct, the silica gel bag will becaught when the Case is sealed and water leakagewill be caused.• Attempting to seal the Case with the bag inserted onlypart of the way will cause the silica gel bag to get caughtby the O-ring and water leakage will occur.• Once silica gel has been used, the moistureabsorption performance will be impaired. Alwaysexchange the silica gel when the Case is opened andclosed.CAUTIONSet the mode dial.After closing the rear lid of theCase, fit the Case’s mode dial(located on the front lid of theCase,) over the top of the digitalcamera’s mode dial.Advice • After fitting the Case's mode dial knob, turn the knob tomake sure that the camera's mode dial switches beforeclosing the Case tightly.• If the camera’s mode dial does not turn when turning themode dial knob, gently push in the knob while turning it.Pay attention to the orientation.Mode dialknob