EN 67Getting to know your camera betterMovie• When [IMAGE QUALITY] is set to [SHQ], the maximum sequential shooting time isapproximately 15 seconds for the cards other than TypeH.• If you use a non-Olympus card or a card used for another application, such as for acomputer, the message [CARD ERROR] is displayed. To use this card with this camera,use the [FORMAT] function to format the card.g “MEMORY FORMAT (FORMAT) Formatting the internal memory or card” (P. 39)This camera uses several lamps to indicate the camera status.Image quality Image size Recording lengthInternal memory Using a 512 MB cardWith sound Withoutsound With sound WithoutsoundSHQ 640 × 480(30 frames/sec.) 11 sec. 12 sec. 4 min.42 sec.4 min.43 sec.HQ 640 × 480(15 frames/sec.) 23 sec. 24 sec. 9 min.21 sec.9 min.27 sec.SQ1 320 × 240(30 frames/sec.) 32 sec. 32 sec. 12 min.42 sec.12 min.54 sec.SQ2 320 × 240(15 frames/sec.)1 min.03 sec.1 min.05 sec.25 min.03 sec.25 min.48 sec.Using a new cardLamp indicatorsLamp StatusSelf-timer lamp When set to [Y 12 SEC]The lamp lights for approximately 10 seconds, blinks forapproximately 2 seconds, and then the picture is taken.When set to [Y 2 SEC]The lamp blinks for approximately 2 seconds, and then thepicture is taken.Card access lamp Blinking: A picture is being recorded, the camera is readinga movie, or images are being downloaded (whenconnected to a computer).• Do not do any of the following while the card access lamp isblinking. Doing so may prevent the image data from beingsaved and render the internal memory or card unusable.• Open the battery compartment cover/card cover• Remove the batteries.• Connect or disconnect the AC adapter.Green lamp of themonitorLit: The focus and exposure are locked.Blinking: The focus and exposure are not locked.• Release your finger from the shutter button, re-positionthe AF target mark on the subject and press the shutterbutton halfway again.