Omcan FP-IT-0004 Instruction Manual

Contents

6Technical SpecificationsThe cutter is started and stopped by means of a button connected to an auxiliary control circuit preventingaccidental startup after an outage.Model FP-IT-0004Horsepower 0.5 HPCapacity 3.3 L / 3.5 QTElectrical 110V/60/1Weight 22 lbs. / 10 kgs.Dimensions 15.75” x 13” x 11” / 400 x 330 x 279mmItem Number 10832MaintenanceFor good mincing performances, the blades must be sharp. If necessary, have them sharpened by aspecialized person. This machine does not require any further lubrication. Should the machine make anyunusual noise after a certain period of time, this may be due to a loosening of the belt. Screw the belt-tighteneron the side of the motor under the base.InstallationOperationPlace the machine on a suitably plane, smooth and dry surface sufficiently strong to support the machineweight. Install near an outlet complying to local regulations.Before completing the connections, check that the mains correspond to the data shown on the plate.• To start the machine, press the green button.• Insert the food to mince through the special opening on the lid.• Take into account that prolonged use will mash the products.• After completion, open the lid by turning the knob on the horizontal bar by ¼ turn to the left, and pull up thebar.• Take the blade holding pin away then remove the vessel from its seat.