Manuals database logo
manualsdatabase
Your AI-powered manual search engine

PAC STORAGE PS 3012 Hardware Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Page 29 preview
Page 30 preview
Page 31 preview
Page 32 preview
Page 33 preview
Page 34 preview
Page 35 preview
Page 36 preview
Page 37 preview
Page 38 preview
Page 39 preview
Page 40 preview
Page 41 preview
Page 42 preview
Page 43 preview
Page 44 preview
Page 45 preview
Page 46 preview
Page 47 preview
Page 48 preview
Page 49 preview
Page 50 preview
Page 51 preview
Page 52 preview
Page 53 preview
Page 54 preview
Page 55 preview
Page 56 preview
Page 57 preview
Page 58 preview
Page 59 preview
Page 60 preview
Page 61 preview
Page 62 preview
Page 63 preview
Page 64 preview
Page 65 preview
Page 66 preview
Page 67 preview
Page 68 preview
Page 69 preview
Page 70 preview
Page 71 preview
Page 72 preview
Page 73 preview
Page 74 preview
Page 75 preview
Page 76 preview
Page 77 preview
Page 78 preview
Page 79 preview
Page 80 preview
Page 81 preview
Page 82 preview
Page 83 preview
Page 84 preview
Page 85 preview
Page 86 preview
Page 87 preview
Page 88 preview
Page 89 preview
Page 90 preview
Page 91 preview
Page 92 preview
Page 93 preview
Contents
  1. Table Of Contents
  2. Table Of Contents
  3. Table Of Contents
  4. Table Of Contents
  5. Safety Precautions
  6. Important Notice
  7. About this Manual
  8. Introduction
  9. Major Components
  10. Power Supply Unit with Built-in Cooling Module
  11. Single Controller Models
  12. Front Panel
  13. Rear Panel
  14. Internal Backplane
  15. Drive Tray Bezel
  16. Controller Module of Expansion Enclosures
  17. Super Capacitor & Flash Backup Module
  18. PSU & Cooling Module
  19. Expansion Enclosure Status Monitoring
  20. Hot-Swapping
  21. Installation Procedures Overview
  22. Pre-installed Components
  23. SAS Interface
  24. Hard Drive Designation
  25. Installing the Hard Drive into Drive Tray (PS 3025 excluded)
  26. Installing the Drive Tray into the Enclosure
  27. Installing Host Boards
  28. Removing the Controller
  29. Host-Side Topologies
  30. Maximum Concurrent Host LUN Connection ("Nexus" in SCSI)
  31. Fibre-Host Topologies
  32. Fibre Cabling
  33. Simple End-to-End Connection
  34. Switched Fabric Connection (Dual Controller)
  35. Switched Fabric Connection (Single Controller)
  36. SAS-Host Connections
  37. DAS (Direct-Attached Storage) Connection with Redundant Host Path
  38. DAS (Direct-Attached Storage) Connection to Two Servers
  39. Network & Host Connection Topologies
  40. High Availability IP SAN with Redundant Controller
  41. Single Controller with Fault-Tolerant Path
  42. High Availability IP SAN (Recommended Cabling Method for Remote Replication)
  43. High Availability IP SAN with Port Trunk (Remote Replication Enabled)
  44. Hybrid Host Connections
  45. Utilizing Hybrid iSCSI Ports for Data Replication
  46. SAS Expansion Enclosure Configuration
  47. Dual Controller Expansion Connection
  48. Single Controller Expansion Connection
  49. Management Console Connections
  50. Power Cords Connection
  51. Power On Status Check
  52. System Monitoring
  53. Drive Tray LED
  54. Unified Storage System Controller LEDs
  55. G Ethernet Management Port LEDs
  56. G SAS Expansion Port LEDs
  57. G Fibre Channel Port LEDs
  58. Converged Host Board
  59. Controller LED for 12G SAS Expansion Enclosure Models
  60. PSU & Built-in Cooling Module LEDs
  61. System Maintenance
  62. Restoring Default Settings
  63. Replacing the Host Board
  64. Replacing Memory Module(s)
  65. Supercapacitor Fault Conditions and Precautions
  66. Replacing Flash Backup Module
  67. Detecting a Failed PSU
  68. Replacing Hard Drive
  69. Replacing Hard Drive for PS 3025 only
  70. Slide Rail Kit Installation Guide
  71. Slide Rail Kits
  72. Tools Required
  73. Installation Procedure
  74. Slide Rail Kit
  76. Once Mounted
  77. Safety Reminders
  78. Appendix
  79. Power Supply
  80. Environment
PAC STORAGE PS 3012 Hardware Manual Manual pdf 81 page image
81Replacing Hard Drive for PS 3025 onlyTo replace a hard drive for GS 3025A, and 2.5” drive for 3025B models, follow these steps below.Gently pull out the clips on both sides of the tray.If you are using a MUX board, please loosen the M3 screw first, and then remove the clips.(without MUX board)(with MUX board)The drive can be fully released after both the clips are removed.(without MUX board)
/ 93
Related manuals for PAC STORAGE PS3024
PAC STORAGE PS 2024 Hardware Manual first page preview
PAC STORAGE PS 2024 Hardware Manual
PAC STORAGE PS 3000 G3 Series Hardware Manual first page preview
PAC STORAGE PS 3000 G3 Series Hardware Manual
PAC STORAGE PS 2000 Series Hardware Manual first page preview
PAC STORAGE PS 2000 Series Hardware Manual
This manual is suitable for:
PS3024PS 3000 Gen 1 SeriesPS 3012PS 3016PS 3025
Manuals database logo
manualsdatabase
Your AI-powered manual search engine