12OFF-BOARD CHARGERWARNING: Do not plug in charger cable if wall cord or battery harness is damagedNOTE: Ensure battery charging and storage locations comply with OSHA and any governing agencies’standards based on your particular location and applicationSet the Battery Type switch to match the battery configuration of the machine• Up for Lead Acid batteries• Down for sealed, maintenance free AGM batteries1. Connect the charger to the wall outlet2. Connect the red plug pictured below to the battery harness below the control panel at the rear of the machineOff-board status LEDs:• Primary (green) LED:• Blinking slowly: Batteries are still below 80% of full charge• Blinking rapidly: Batteries are above 80% of full charge• Solid green: Batteries are fully charge• Fault (red) LED:• See the charger manual for fault informationRETURN TOTABLE OFCONTENTS