Paloma PRS-150N Owner's Manual And Installation Instructions
                                    | |
Contents
| 
OPERATIONTurning Timer(s) OFF (deselecting a timer)To deselect a timer, press and release the selected timer button (‘Timer 1’ or ‘Timer 2’ button). The relevant timerbutton LED will extinguish and the burner will turn on (because the Power button is turned ON). Note: If a secondtimer was also selected and the current time was outside the timers programmed on period and pre-heat time, theburner would not operate when the first timer is deselected.Timer Over-Ride FunctionThe ‘Over ride’ button can be operated to turn the burner off when the heater is operating in a timer on period or toturn the burner on when the heater is operating in a timer off period.• If a timer is selected and the heater is operating within a timer programmed time period or pre-heat period(burner on), the timer may be over-ridden and the burner turned off by pressing and releasing the ‘Over ride’button. The Over ride button LED will illuminate and flash and the Power button LED will change from red togreen after the burner is extinguished.If the ‘Over ride’ button is pressed and released once again, the Over ride button LED will extinguish and theburner will operate provided the current time is within the selected timers programmed on period includingpre-heat period and provided the set temperature is higher than the room temperature.• If a timer is selected and the heater is operating outside a timer programmed time period (burner off), the timermay be over-ridden and the burner turned on by pressing and releasing the ‘Over ride’ button. The Over ridebutton LED will illuminate and flash, the timer button LED will remain on and the burner will operate provided theset temperature is higher than the room temperature.If the ‘Over ride’ button is pressed and released once again, the Over ride button LED will extinguish and theburner will turn off provided the current time is not within the selected timers programmed on period includingpre-heat period.AUTO OFF TIMER OPERATIONThe Auto Off Timer can be activated so that the heater will automatically turn OFF after a preset time period.1. Press and release the ‘Power’ button to turn the heater on.2. Press and release the ‘Auto Off Timer’ button. 1h (1 hour) will be shown of the display and the Auto Off Timerbutton LED will illuminate.3. Each consecutive press and release of the ‘Auto Off Timer’ button will change the OFF time setting up to amaximum of 12h (12 hours).After a 5 second delay the display will start counting down in hours and minutes and the Auto Off Timer button LEDwill flash. When the counter reaches zero the heater will automatically turn OFF and all LED's will extinguish.Notes:• Possible time settings are 1h, 2h, 3h, 4h, 5h, 6h, 7h, 8h, 10h & 12h.• The set temperature must be higher than the room temperature for the burner to operate. Note: When firstturned ON the burner will operate for a period of approximately three minutes regardless of the room and settemperatures.ECONOMY MODEEconomy mode is designed to increase the efficiency of the heater.To activate economy mode: Press and release the ‘Economy’ button. The LED on the economy button willilluminate green and the heater will operate as follows:a) If the room temperature reaches the set temperature the economy program is activated and the set temperatureis automatically reduced by 1°C after a delay of 30 minutes.b) The set temperature is automatically reduced by another 1ºC after another 30 minute delay.This subtle reduction in temperature is not noticed by the user and the set temp is not altered on the display howeverthe efficiency of the heater is increased.To deactivate economy mode: Press and release the ‘Economy’ button. The LED on the economy button willextinguish, the heater will exit economy mode and the set temperature will return to the displayed set temperaturevalue.11 |
Related manuals for Paloma PRS-150L
manualsdatabase
Your AI-powered manual search engine