53FAQs, etc.Technical Information16 7 8394 51015141312112* Mark: Applicable input signal for Component (Y, P B, PR ), HDMI and PCInput signal that can be displayedhorizontal frequency (kHz) vertical frequency (Hz) COMPONENT HDMI PC525 (480) / 60i 15.73 59.94 * *525 (480) /60p 31.47 59.94 * *750 (720) /60p 45.00 59.94 * *1,125 (1,080) /60i 33.75 59.94 * *1,125 (1,080) /60p 67.43 59.94 *1,125 (1,080) /60p 67.50 60.00 *640 × 400 @70 31.47 70.08 *640 × 480 @60 31.47 59.94 *Macintosh13” (640 × 480) 35.00 66.67 *640 × 480 @75 37.50 75.00 *852 × 480 @60 31.47 59.94 *800 × 600 @60 37.88 60.32 *800 × 600 @75 46.88 75.00 *800 × 600 @85 53.67 85.08 *Macintosh16” (832 × 624) 49.73 74.55 *1,024 × 768 @60 48.36 60.00 *1,024 × 768 @70 56.48 70.07 *1,024 × 768 @75 60.02 75.03 *1,024 × 768 @85 68.68 85.00 *Macintosh 21” (1,152 × 870) 68.68 75.06 *1,280 × 1,024 @60 63.98 60.02 *1,366 × 768 @60 48.36 60.00 *Note• Signals other than above may not be displayed properly.• The above signals are reformatted for optimal viewing on your display.PC Input Terminals ConnectionPin No. Signal Name Pin No. Signal Name Pin No. Signal NameR 6 GND (Ground) 11 NC (not connected)G 7 GND (Ground) 12 NCB 8 GND (Ground) 13 HD/SYNCNC (not connected) 9 NC (not connected) 14 VD5 GND (Ground) 10 GND (Ground) 15 NC• Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and verticalscanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200lines.)• Some PC models cannot be connected to the set.• There is no need to use an adapter for computers with IBM PC/AT compatible D-sub 15P terminal.• The maximum resolution: 1,280 × 1,024If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity.• Signal Names for D-sub 15P ConnectorPin Layout for PC InputTerminal