Panasonic 9TGCF-181A Operating Instructions Manual

35 TroubleshootingDo not interrupt the reinstallation procedure be-fore completion, for example by turning off thecomputer or pressing Ctrl + Alt + Del , asthis may prevent Windows from starting up, or maycause data to be lost so that the reinstallation pro-cedure cannot be executed.When a message appears instructing you to insertthe next CD, insert the recovery CD showing thenext number in the sequence, and then select [OK].If the message [The media does not contain thecorrect file] appears, select [OK]. A message willappear instructing you to insert the next CD.Confirm that the proper recovery CD has been in-serted by opening the cover of the CD/DVD driveand then close the cover, then select [OK].CAUTION10 At the confirmation message , press Y .The operation of reinstallation for the hard disk starts au-tomatically. (The operations take about 20 minutes.)17 Perform the first-time use operation ( page 13 step6- page 15 step10 ).18 Run the Setup Utility and change the settings where nec-essary.If additional instructions are included with the com-puter, be sure to read them. It may be necessary toperform additional operations during the followingprocedures.NOTE11 After the reinstallation procedure completes, this screenshould appear.Remove the recovery CD, and then press any key.The computer will be shut down.----------------------------------------------------------------[Recovery] is complete.Windows(R) XP Professional install wizard will start after reboot.Please remove the Product Recovery CD-ROM.After tuning off the power, disconnect the CD/DVD-ROM drive, and turnthe power on again.----------------------------------------------------------------12 Remove the CD/DVD Drive.13 Turn on the computer, and press F2 while [Panasonic]boot screen is displayed.The Setup Utility will start up.If the password has been set, enter the Supervisor Password.14 Press F9 .At the confirmation message, select [Yes] and pressEnter . (The Setup Utility settings will return to theirdefault values. Even the security settings with the ex-ception of the password(s) will return to their defaultvalues.)15 Select [Exit] and then select [Save Current Values], thenpress Enter .At the confirmation message, select [Yes] and pressEnter .16 Turn the computer off by sliding the power switch.