5.4 SD Memory Card Operation5-15 When power is ON1. Change to the PROG. mode.2. Attach an SD memory card that houses the auto execution file "autoexec.fp7" and thecomment file "comment.fp7" for a project to the CPU unit.3. Close the cover.4. Until "COPY LED" flashes (approx. 5 seconds), set the RUN/PROG./COPY switch to"COPY".Transmission of project data is started. Once "COPY LED" starts to flash, thetransmission process continues if you let go off the COPY switch. Once transmissionis completed, "COPY LED" turns off.KEY POINTS Copying of a project triggered by the COPY switch does not depend onsettings for the card operation switch. Operation starts whether the switchis set to CARD or ROM.5.4.6 Precautions Concerning SD Memory Card Operation In an SD memory card to be used, create an "AUTO" folder, and save an auto execution file"autoexec.fp7" and a comment file "comment.fp7". While the card project regular operation mode LED [COPY] (Green) is on, do not remove theSD memory card from the slot. It may cause damage to the project. If the card operation switch is set to "CARD" while no SD memory card is inserted, a self-diagnosis error will result. If the unit cannot access a project in the SD memory card while the card operation switch isset to "CARD" and SD memory card operation is in progress, a self-diagnosis error will result.Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
