2-102.5 Calendar timer2.5.1 Area for calendar timerWith the clock/calendar function, data indicating the hour, minute, second, day, yearand other information stored in the special data registers DT9053 to DT9057 can beread using the transmission instruction and used in sequence programs.Special dataRegister No.Upper byte Lower byte Reading WritingDT9053 Hour dataH00 to H23Minute dataH00 to H59Available Not availableDT9054 Minute dataH00 to H59Second dataH00 to H59Available AvailableDT9055 Day dataH01 to H31Hour dataH00 to H23Available AvailableDT9056 Year dataH00 to H99Month dataH01 to H12Available AvailableDT9057—Day- of - the-week dataH00 to H06Available AvailableNote:1. The area above is available for the FP-e unit with a calendar timer function.2. The value is not fixed initially when the battery is connected. Set the appropriate value to the calendartimer.Lithium battery is included in the FP-e unit, but it is not connected to the unit. Connect the battery to theunit before using the FP-e controller.3. Put in a new battery within a minute after removing the old battery.4. A calendar timer is available only when a battery is installed.2.5.2 Setting of calendar timer functionThere are two ways to set the calendar timer function as described below.- Setting using FPWIN GR1. Press the [CTRL] and [F2] keys at the same time, to switch the screen to [Online].2. Select “Set PLC Date and Time” under “Tool” on the menu bar.PLC Date and Time setting dialog boxThe above steps display the “Set PLC Date andTime dialog box” shown on the left. Input the date and time, andclick on the “OK” button.Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
