Panasonic AG-DVC30 Operating Instructions Manual

Also see for AG-DVC30E: Service manual

Contents

Panasonic AG-DVC30 Operating Instructions Manual Manual pdf 82 page image

82 (E)Before calling for service (cont.)I can’t hear any sound from the camera-recorder’s speaker.O Have you turned down the camera-recorder’svolume control too far?In the VCR mode, adjust the volume levelusing the multi dial. (P49)I can hear two sets of sound.O Have you selected “MIX” as the 32K (12bit)AUDIO item setting on the PLAYBACKFUNCTION screen? (P73)O If you perform audio dubbing on a tape thatwas recorded with “32K (12bit)” selected asthe AUDIO REC item setting on theRECORDING SETUP screen, you will hearthe sound heard during recording and that ofthe audio dubbing. (P75)When I performed audio dubbing on anexisting recording, the original sound waserased.O If you perform audio dubbing on a tape thatwas recorded with “48K (16bit)” selected asthe AUDIO REC item setting on theRECORDING SETUP screen, you will erasethe original sound on the tape. To leave theoriginal sound intact, make sure that “32K(12bit)” is selected as the item setting whenyou shoot the original recording. (P75)Playback (sound)I can’t remove the cassette tape.O Is power still being supplied to the camera-recorder? (Is the power from the AC adapterand battery supplied properly?)So long as the power is supplied, you canremove the cassette even if the POWERlever is at the OFF position.I can remove the cassette but I can’t performany other operations.O Has condensation formed?If it forms, the only operation you can performis to remove the cassette. Wait until thecondensation has dried out. (P83)O If the cassette cover is closed immediatelyafter sliding the EJECT switch to open thecassette cover, you may no longer be able toperform any operations other than eject.If you did this, slide the EJECT switch againto open the cassette cover, check that thecassette mechanism has finished ejecting thecassette, and then close the cassette cover.The remote control unit does not work.O Has the button battery in the remote controlunit run out?If the remote control fails to work even whenit is operated near the camera-recorder’sremote control sensor, it means that thebutton battery has run out. Replace it with anew one. (P24)O Is the remote control setting the same for theremote control unit and the camera-recorder?If the REMOTE item setting does notcorrespond between the two units, theremote control unit will not work. (P24, P78)I hear a rattling sound when I tilt the camera-recorder back and forth.O There are some parts in the structure of thecamera unit that make a rattling sound in theVCR mode or when the POWER lever is atthe OFF position. This is not a sign thatsomething is broken.Other