58DubbingUse the dubbing function to copy the contents of S-VHS (or VHS) cassettes onto DV cassettes orrecord the television.1 Connect this unit to a video deck or atelevision. (Page 55)2 Press the CAMERA/VCR button and switch tothe VCR mode.3 Turn on the power of the external unit, and playback the tape.4 To start recording video signals from theconnected devices, press two VCR RECbuttons at a time.On the remote control, while pressing the RECbutton, press the PLAY button.• If you press these two buttons during pause,the unit will go to shooting standby mode.Each time the [h] button of the OPERATIONlever is pressed, the unit switches betweenshooting and the shooting standby mode.5 Move the OPERATION lever [g] to stoprecording.6 Stop playback on the external unit.Analog/digital (AD) conversionYou can use this unit to convert analog to digitalsignals. In the setup menus, AV IN/OUT SETUPscreen, set DV OUT to “ON”. (Page 75)This enables you to output digital images, whichwere input as analog signals from an external unit,through this unit’s DV connector to another digitalvideo unit.• Normally, set DV OUT to “OFF”. Images may bedisrupted if you set it to “ON”.• You can also use an S-video cable.• Connecting external units (Page 53)Analog inputYou cannot adjust the audio level.CAMERAVCRCOUNTER RESET TITLESTILL ADV PAUSE STILL ADVINDEX—VOL +STOP INDEXMULTI/P-IN-P REC A.DUBPLAY/REW FF/ZOOMVCR REC buttonsRemote controlorAnalog signalsDigital signalsVideo deck, etc.Another digital videounitThis camera-recorderCamera