Panasonic AG-HMC40 Operating Instructions Manual

Also see for AG-HMC40: Brochure User manual

Contents

Panasonic AG-HMC40 Operating Instructions Manual Manual pdf 37 page image

37 ShootingRemoving SD Memory Card1 Slide the card cover release lever, and openthe SD Memory Card cover.Make sure that the SD Memory CardACCESS lamp is not flashing orange beforeopening the cover.2 Press the center of the SD Memory Card sothat it pops out slightly, and pull the cardstraight outwards.SD Memory Cardaccess lamp21Do not remove the SD Memory Card or switch offthe power in the following circumstances. Doingso may damage your SD Memory Card.1) While the SD Memory Card ACCESS lamp isflashing orange after inserting an SD MemoryCard.) While the SD Memory Card ACCESS lampis flashing during recording, recordingfinalization, and other operations.Protecting SD Memory CardsMove the write-protect switch on the SD MemoryCard to the “LOCK” position to prevent recordedcontents being accidentally erased from the card.32LOCKWrite-protectswitch••Repairing SD Memory CardsNever remove the SD Memory Card or disconnectthe battery or DC cable while the SD MemoryCard ACCESS lamp is flashing, as doing so maydamage the SD Memory Card. In the event the SDMemory Card is removed while the SD MemoryCard access lamp is flashing, or the battery orDC cable is disconnected during a recording orrecording finalization process, a repair verificationscreen will appear the next time the power isturned on to allow errors to be repaired.Select YES to begin repairing. When repairing iscomplete, “REPAIR FINISHED” will be displayed, andthe camera will switch to the recording paused screen.Select NO to switch directly to the recordingpaused screen without repairing.Memory cards cannot be repaired with the cameraif NO is selected, but can still be repaired by usingthe AVCCAM Restorer∗ contents repair software.An SD Memory Card on which an error occurredcan be repaired by using either the camerathat was used for the shooting, or the AVCCAMRestorer contents repair software.A repair confirmation message may be displayedafter inserting an SD Memory Card which has noerror, but repair will not be performed even whenYES or NO is selected.Repair may take up to 0 minutes or so dependingon the places where the errors occurred on the card.Use a battery with an adequate charge or the AC adapter.If the repair operation has failed, “SYSTEMERROR TURN POWER OFF” will be displayed.In this case, please use the AVCCAM Restorercontents repair software.Depending on the status of the data, it may not bepossible to restore all data completely. In this case,it will no longer be possible to play back the clipsthat were recorded before the SD Memory Cardwas ejected or the power was turned off.Clips with a total recording time of less than 10seconds may not be able to be repaired.Shot marks added during recording cannot berepaired.∗ AVCCAM Restorer is included on the suppliedCD-ROM. For details on how to install it, refer toinstall.txt.For details on how to use it, read the operatinginstructions (PDF file).The AVCCAM Viewer can also be downloadedfrom the following website.https://eww.pavc.panasonic.co.jp/pro-av/••••••••