Panasonic AG-HMX100 Operating Instructions Manual

Also see for AG-HMX100E: Operating instructions Operating instructions Operating instructions

Panasonic AG-HMX100 Operating Instructions Manual Manual pdf 20 page image

20Chapter 2 Registering Settings and EffectsThe EVENT SET and EVENT RECALL buttons are used toregister and call events, respectively.The currently selected event number is shown in the eventnumber display area of the setting screen. [E] is shown fora null event.EVENT00ERegistering the Current Settingsand Created Effects as Events1 Press the EVENT SET button.The button is lighted.2 Select the event number in the range of 0 to 99.Enter the number using the numeric keys orincrement or decrement the value using the +or – key, respectively.3 Press the key.The EVENT SET button flashes for approximately 2seconds, and then goes off.To register a series of effects as eventsUp to 10 effects can be consecutively registered as eventswith numbers 50 to 59, 60 to 69, 70 to 79, 80 to 89, or 90 to99.Since those 10 events can be called and executedconsecutively, the key frame settings can also beregistered as events.Calling Events1 Press the EVENT RECALL button.The button is lighted.2 Select the event number. Enter the numberusing the numeric keys or increment ordecrement the value using the + or – key,respectively.3 To call the settings, press the key.The EVENT RECALL button goes off.The selected event is called and the settings of thesetting screen are changed to those registered asthe event.4 Press the AUTO TAKE button.The effects registered as the event are executed.If one of the events in which a series ofeffects were registered is calledIf 10 events are consecutively registered with eventnumbers in the range of 50 to 59, 60 to 69, 70 to 79,80 to 89, or 90 to 99, the settings of the first event arereproduced when one of the 10 events is called. NOTEWhen the event is called, the settings of the input source usedduring creation of the effects are not reproduced. The effectsare executed with the currently available input source settings.Thus, first reproduce the same input source settings as thoseduring effect creation, and then call the event to execute.Clearing Event Memory1 Press the EVENT RECALL button.The button is lighted.2 Select the event number. Enter the numberusing the numeric keys or increment ordecrement the value using the + or – key,respectively.3 Press the key while holding down the SHIFTkey.The EVENT RECALL button goes off.The memory of the selected event is cleared.Event Memory Operation