Panasonic AG-HPD24PJ Operating Instructions Manual

Also see for AG-HPD24E: Operating instructions

Contents

Panasonic AG-HPD24PJ Operating Instructions Manual Manual pdf 106 page image

Synchronous Playback Mode (SYNC PB): Displaying and Managing Clips 43Synchronous Playback Mode (SYNC PB)Displaying and Managing ClipsOperations are performed using the same operations as inmain mode.On the slave side, you can check clips by opening thethumbnail screen, but control is restricted to THUMBNAIL,Up/Down/Left/Right cursor button operations.This chapter will explain the differences from main modeoperations.◆ NOTE:• The following operations cannot be performed.- Copying clips- Deleting clips- Repairing bad clips- Reconnecting incomplete clips- Editing thumbnails- Adding meta data during recording (recording is not performed)- Formatting P2 cardsAll thumbnail (ALL CLIP) selection is the only operationavailable in SYNC PB mode. Selected clips and TEXT MEMOclips cannot be displayed.Use the master side controls to start playback. Slave sidecontrols are not available. Clip playback will not start when athumbnail screen on the slave side is open.◆ NOTE:• Video and audio distortion between clips may occur when playingback clips with different video formats (1080i and 720p), or differentcompression formats (DVCPRO HD, DVCPRO50, DVCPRO, DV,AVC-Intra 50, and AVC-Intra 100).The master side enables variable playback like main mode. Itdoes not function on the slave side.◆ NOTE:• Independent right and left systems: Video is shown only on the LCDand no output is made to SDI.However, when the SETUP - VIDEO - DISCRETE BLACK menusetting is set to OFF, video is output only via the SDI output on themaster side.• Side-by-side, frame-packing system: Only video from the masterside is output to the LCD and SDI/HDMI (video on the R side isidentical to master side video).Displaying and revising clip information on the master side isperformed like in main mode. Clip information on the slaveside cannot be displayed or revised.Like in main mode, you can use the following steps to displayand check P2 card slot status, P2 card usage and other cardinformation for the master side on the screen. You can notdisplay or revise the information on the slave side.Changing Thumbnail DisplayPlaying Back ClipsPlaying Back at Variable SpeedViewing and Repairing ClipInformationChecking Card Status